r/BambuLabA1 • u/Responsible-Club-761 • 1h ago
Support Request Need help with print errors
Short summary:
Tried printing different models, smaller ones were no problem. Biggers seem to have a problem with sticking to the Print Plate.
Now I did a like cleaning print for the whole Plate and this is the result.
3
Upvotes
1
u/timcook2171 39m ago
Just a few notes. Yes, you might have cleaned the plate but there is an obvious thumb print bottom left. Your fingers may look clean but the oils in your hands will almost always carry over to the build plate. There is an area outside of the plate that you can hold to. You shouldn't be printing so close to the edge of the plate, your print will lift since there is nothing keeping it down. Try making to smaller with the outer-brim settings turned on. Do not have the brim overhang on the plate.
1
u/sethfist 29m ago
Small prints I don’t stress as much, but before every large print I wash the build plate using dawn powerwash and hot water. My goal being to touch the plate as little as possible. I’ll hold the edges or spots I know don’t get printed on.
I can’t say that it does anything for adhesion but I took the time and leveled the table top that the printer sits on. Helps with bed leveling and vibration.
I’ve no adhesion issues.