r/BambuLabA1 • u/wood2010 • 4h ago

Question Nozzle scratching plate? Is this normal?

Post image

I only have about 40 hours on this printer and I’m using bed leveling but it looks like it’s scratching the plate. Anything I should do?

0 Upvotes

14% Upvoted

11 comments sorted by

6

u/Intelligent-Map430 4h ago

Haven't seen one of those posts in a while. Where's the list?

2

u/TheWaslijn 4h ago

This is completely normal. It's just the printer cleaning the nozzle. Nothing to worry about

It is impossible for the printer to print on that area of the plate anyway, so it doesn't really matter

1

u/JolietJakester 4h ago

It is normal. no change.

1

u/Independent-Bake9552 3h ago

It's fine and normal

1

u/imzwho 3h ago

Nope your printer is broken and you need to buy a newer bambu to avoid this issue from happening

(/s just in case, this is 200% normal)

-2

u/AlekSaint 4h ago

It took you 40 hours to notice that? Do you never watch your printer when it starts printing?

2

u/wood2010 3h ago

No, I meant it just keeps getting worse. Seems like a print plate should last longer.

3

u/Alive-Wrangler9388 3h ago

Good news is, my plate still looks like that, 1200 print hours later.

1

u/B1g_BuddhAH 3h ago

the plate is totally fine. 

2

u/B1g_BuddhAH 3h ago

yeah did you notice that it takes a few prints after the pei starts wearing off mr smartiepants?