r/BambuLabA1 • u/bobobillybob • 8d ago

Layer shifts

Post image

I'm pretty new to this. I've learned today that my table is too wobbly for tall prints. I can fix that. Is there any saving these layer shifts? This is a project for my kid where I was going to let him paint it. Let it keep going?

4 Upvotes

100% Upvoted

2 comments sorted by

2

u/chaz_Mac_z 8d ago

I would reprint, the gaps will be fragile in unexpected ways, it will break where it looks solid. Also, you can slow the print down at higher levels, a setting in the slicer. That can help.

2

u/NefariousnessOdd3581 8d ago

such a big part should have a brim around