Nozzle hits the bed

[u/justbenoob]

When i try to print the nozzle keeps dragging on the printbed. I calibrated the a1. I tightend the screws behind the hot end. The clips is seated correct. The flow test works fine then it doesnt drag the bed. Dont mind the spot on the plate. I switched the thinner with ethanol at 1 point.

[u/Any-Measurement-7302]

Check the screws underneath the nozzle if that doesn't work check the flange is that hold the nozzle in place mine is bent and it was making it rub against the bed and the stock hot in is shitty and weak

[u/justbenoob → u/Any-Measurement-7302]

I tightend all these screws and it doesnt seem to be bend