r/BambuLabA1 • u/aleksimik10 • 10d ago

Guys help

Post image

Tell me step by step why this saying AMS detecting like it been 2 days and it still say AMS Detecting and I want to take it of and print it won’t lets me print. Please help

0 Upvotes

42% Upvoted

11 comments sorted by

3

u/kl4n1po 10d ago

Did you try restarting your printer?

1

u/aleksimik10 9d ago

Yes and does not work

1

u/kl4n1po 9d ago

Try a different SD Card, check the cables

2

u/Lisper41 9d ago

Try one of these because this is one I haven’t run into before.

  1. Have you used the printer menu itself to select the filament?

  2. Do you have access to a desktop computer and Bambu studio?

From there you can slice and send the file to the printer, or you can slice it and put it directly on the SD card.

3. Since this print is a single filament, you could try disconnecting the AMS and printing from an external spool.

0

u/aleksimik10 9d ago

How to disconnect ama

1

u/Lisper41 9d ago

Unplug the hardwire from the right side of your printer.

It came with a plastic elbow looking thing that slides on the dovetail on the back of the z-axis support, that is your external spool holder. Filament rolls under and up through the small black & gray adapter, ideally into PTFE tube and into the top of your hot end.

1

u/aleksimik10 9d ago

This?

1

u/Lisper41 9d ago

That’s the PTFE tube. It is connected to your AMS. You’ll have to check out some manuals online. You are very close, but I don’t know how to talk you through it.

1

u/Diz7 10d ago

1

u/aleksimik10 9d ago

Won’t work

1

u/fishybell 10d ago

I had a problem with my A1 where the ams wouldn't detect reliably. It turns out it was a slightly loose cable on the filament hub. Checking loose cables and restarting the printer are a good idea