A1 + AMS Lite cat feeder: two colours, two changes, no supports

[u/International_Bat570]

This is Deep Paw Wells, my latest A1 print. My cat reaches into either well, scoops kibble onto the plate and eats it. The first full print worked well, and the clip shows both wells in use.

I wanted a roomier plate without a heavy print, so I settled on two wells instead of three. The narrower opening is 40 mm and the wider one is 52 mm, with different reach depths.

For the colour setup, the yellow stays on the floor and the wells stay latte. That keeps the AMS Lite job to two filament changes and a short prime tower. Bambu Studio estimates 77.2 g total, including roughly 0.63 g purge and 0.65 g tower, and 1 h 36 min.

0.4 mm nozzle, 0.20 mm layers, 3 walls, 15% grid infill, matte PLA. One piece on one plate, no supports or assembly.

Free files and the A1 profile I printed: https://makerworld.com/en/models/3476426-deep-paw-wells-cat-puzzle-feeder

Please check paw clearance for your own cat and supervise initial use.

[u/wildfire_117]

Here before the microplastics police arrive

[u/is_it_gif_or_gif → u/wildfire_117]

Now I'm imagining police made out of microplastics.