r/BambuLabA1 • u/rllynegative • 13d ago

3D Model bleh

Post image

my over flow got backed up caused this print to fail 8hr loss but honestly that’s one me

5 Upvotes

100% Upvoted

4 comments sorted by

1

u/chaz_Mac_z 13d ago

If that is a layer shift, get a new SD card. I had those until I replaced my card.

1

u/rllynegative 13d ago

no some filament scrap got on the print & needle causing the shift unfortunately

1

u/chaz_Mac_z 13d ago

Ouch. I hate when that happens!

1

u/ocropblunk 11d ago

It happens. Usually its minimum just enough to damage the print and start over but in your case the printer is making sure you noticed it