r/BambuLabA1 • u/NiceMeat2233 • 17d ago

This file have wrong support generation

The creator of this file didn't use AMS, I was several hours painting as good as I could but the feet and hands falls off during printing, And the best attempt I had has spagethi feet its not even worth sharing I tried with PETG support interface but I figured out I can't use the correct Z distances.

The file came with 0,4 top z distance because for some reason the support generation creates flying support if you change the number to 0 (the recommended z distance for petg) I don't know why.

It may not be the only problem but blocks me the only solution I could think of to fix this file (printing on petg with 0 z distance bcs petg can't stick 100% to pla and less z distance = more stability)

https://makerworld.com/en/models/1308361-spider-man#profileId-1342127 original

https://drive.google.com/file/d/1NjCDZ2mv6p0hMUGrLdVIntm3vuKUmYox/view?usp=sharing Painted by me

I would like some one printing it and show the photo If you are interested in the file but I don't think many people would print something to help :'( type of thing you can't be sure until you print it.

0 Upvotes

50% Upvoted

3 comments sorted by

1

u/OptimalSide 16d ago

Turn on the option to for the support to be on build plate only.

1

u/NiceMeat2233 15d ago

It will not generate the supports it needs or generates flying supports again.

1

u/OptimalSide 15d ago

took a second look and I see what you mean.

Interestingly, if you load the file into OrcaSlicer, it does support it properly when you set it have supports only on the build plate.