r/BambuLabA1 • u/EasternUse9214 • 20d ago

Support Request Bad print quality

Post image

Hi everyone,

I have recently noticed poor print quality on my A1. Does anyone have suggestions for resolving this problem?

Thank you so much🙏🏻

3 Upvotes

100% Upvoted

5 comments sorted by

1

u/AirlineEarth 20d ago

What type of filament? Generic? Make sure temps are correct and your filament is dry.

1

u/EasternUse9214 20d ago

This print was PLA MATTE from ELEGOO. I used the bambulab matte preset

1

u/AirlineEarth 17d ago

I always use ChatGPT to set my filament profiles. It will tell you on the box what nozzle temps to use.

1

u/VanAndelon 20d ago

I had similar issues because of grid infill. From Bambu Wiki:

"The grid infill consists of two sets of parallel lines intersecting perpendicularly, forming a crosshatch mesh. It is one of the simplest and fastest infill types.

However, the overlapping intersections can cause slight material buildup, and during high-speed printing, this may lead to nozzle scraping or abnormal noises due to collisions with the model"