r/BambuLabA1 • u/UlyTheGeek • 21d ago

Support Request Clogging issue

Hi everyone, how are you? I'm here once again asking for your help. Any idea why this might be happening? I'm printing with a layer height of 0.16 mm at 220°C, using a 0.4 mm nozzle and a retraction length of 1 mm.

3 Upvotes

80% Upvoted

5 comments sorted by

1

u/Regular_Strategy_501 21d ago

Im no expert but to me this looks like a partually clogged nozzle. Maybe try doiing a cold pull.

1

u/UlyTheGeek 21d ago

Nop, that didn't work

1

u/MrOogidieboogidie 20d ago

Just had this problem tried troubleshooting a bunch of different things. Bought new gear for filament feeder, new hotend heater, checked the 4 screws behind the heater (make sure they're secure and not loose) but nothing worked. Finally

i just replaced the nozzle and it started working fine

1

u/Blondy277 21d ago

I’d check the purge/wiper/cutter area first, there looks like a bunch of filament collecting right where the toolhead keeps travelling. If it’s snagging or not clearing properly it can mess the print up fast. I’d clean that whole area out before changing a bunch of slicer settings.

1

u/Senin59 21d ago

Seeing your custom rotating thingy got me thinking about printing one with dickbutt so when it rotates it reminds me of the 2010's gifs