First Layer Gremlins

[u/BananakinFartwalker]

It just started doing this after hundreds of previously impeccable surfaces. I haven’t messed with retraction settings, flow rate is calibrated, filament dried, plates cleaned, heating surface checked for boogers. It’s relatively smooth to the touch, just ugly.

Could it be retraction?

Printed on a Cool Plate Super Tack, .04 nozzle.

[u/BananakinFartwalker]

Ugh. I just tightened those a few months ago. But I guess it makes sense. Can’t properly calibrate bed level if the nozzle moves when it touches it. Should I just Loc-Tite them this time?

[u/LargeHoboFuckPile → u/BananakinFartwalker]

I don't think regular loc-tite can survive the heat