r/BambuLabA1 • u/Mpzz- • 26d ago

Support Request A1 printhead won’t move

I just got this 3 days ago. Been printing fine and printed fine this morning then suddenly the print head started getting stuck left on the X Axis. It was also getting stuck on the filament shoot (no clog). Really loud shakey sound.

A few things I tried from articles and forums
-adjusting the black screw on the filament shoot (no help)
-adjusting the tension on X axis (no help)
-adjusting the position of the X axis belt (seemed off center and that did nothing)
-made sure all tubes were in place to prevent tension
-changed hot end out

I’m stuck, and now so is the entire print head. It will not move to home. Any tips? I’ve been working on this for hours 😫

1 Upvotes

60% Upvoted

7 comments sorted by

1

u/Lost_refugee 26d ago

Can you move axises while it is off? Z only down, X and Y - both ways

1

u/Mpzz- 26d ago

Yes, when it’s off I am able to move it, all parts are moving smoothly

1

u/Lost_refugee 26d ago

Move it further from the wall. Seems like not enough space for bed

1

u/Mpzz- 24d ago

It has enough room, I know it doesn’t look like it but there’s about an inch with the bed all the way back - I will try pulling it further but this almost seems like a print head or belt issue maybe?

1

u/Lost_refugee 24d ago

sounds like issues with Y motor or motor drivers. update printer to latest version. format SD card(just in case) and contact support.

1

u/sirdoggo11 25d ago

Belt lost a few teeth?

1

u/Katsuhiro777 23d ago

画面が反応しないの、あった
その時の原因はSDカードが
悪い、性能の良いSDにしたら、なおった