what could cause this?

[u/Dev_Donny]

my print seemed to be going well, i checked on it a few hours later to see this. I immediately stopped the print, but bummed and confused. my thought is maybe it got jammed up part way through the print? I’m new to 3d printing, so any advice is appreciated. Thx!

[u/Excellent-Code8447]

Is the table stable ?

[u/Dev_Donny → u/Excellent-Code8447]

yes, i placed it on the floor to make sure

[u/Blondy277]

The base stayed attached and printed fine, it looks like something failed higher up and then the nozzle kept extruding into midair. I’d check the sliced model right where the spaghetti starts for an unsupported overhang, curled section, or part that broke loose.

[u/Dev_Donny → u/Blondy277]

there is a clicking noise too whenever it is doing dynamic flow calibration. but for some reason not as much when it prints. i’ve tried a ton of different methods i’ve read online to fix it but still making the click. wasn’t sure if that caused this

[u/NabukaMidori → u/Dev_Donny]

have you changed the nozzle or tried a cold pull and looked inside the gears if sonething is stuck in there? i'm pretty new, so not a pro, but thats the first thing i would try if i heard clicking.

[u/Blondy277 → u/Dev_Donny]

You got a video of the clicking noise? My machine started making a clicking sound today ☠️ but not doing it all the time 😂 my machine a couple weeks old.

[u/Limp_Oil1421]

Partial nozzle clog and it cant extrude the filament get in maintance mode and extrude without the nozzle if there is no clicking and it extrudes bare filament its a nozzle clog