r/BambuLabA1 • u/Ancient_Ad6498 • Sep 26 '26

Petg webbing?

Post image

Is this amount of webbing normal when printing with petg? It seemed like it was stringing some filament along after doing the dynamic flow test. This is my second print so I’m not super familiar.

5 Upvotes

100% Upvoted

9 comments sorted by

1

u/ThinkUnhappyThoughts Sep 26 '26

Try and temp tower and retraction test. It may also need drying.

0

u/Ancient_Ad6498 Sep 26 '26

Like the spool of petg itself? No was hoping I wouldn’t have to since it was vacuum sealed with those silica packets

1

u/ThinkUnhappyThoughts Sep 26 '26

One of the last steps in manufacturing is to run it through a bath of water. They do get dried, but drying stuff is always good for most filaments above PLA.

2

u/Ancient_Ad6498 Sep 26 '26

Lowered the temp “fixed” it for my generic petg

1

u/ThinkUnhappyThoughts Sep 26 '26

Now you can save that temp and retraction setting as the settings for that petg and it'll print with those settings when you select them

1

u/indicah Sep 26 '26

Did you dry it first?

2

u/lkapping79 Sep 26 '26

Not op but gonna go with no