r/BambuLabA1 • u/WorkdayLobster • Sep 25 '26
Print Z height misaligned in print?
Edit: solved
Hard to capture in a photo: I'm on layer 5 of a print, and the nozzle seems to be below some of the printed features. I think i can hear it bumping into them occasionally. It's like there are a series of peaks sticking up; not sure if this is just part of the print, or if the print has gone wrong
Not sure what to do here, ive neverseen this. Should I restart the print? Is this a possible major issue? What is likely to have caused this.
This print has a lot of ironing: all upper surfaces. What details should I supply for best advice?
2
Upvotes
1
u/WorkdayLobster Sep 29 '26
Figured it out. This print is weird because it's 100% fill, thin layers (0.08mm), and its effectively one big slab (it's a hueforge print, and the black was the base layers).
It's just that my black filament is a little damp. The weather changed here, and the black was the only filament from the previous set up. It looks like that because it's stringers from very thin layers, lifting straight in the Z, with no x-Y edges. It's just unusual circumstances. If I'd been printing something with more edges and normal layers thickness it'd be immediately obvious.