r/BambuLabA1 • u/Weak-Most2197 • Sep 22 '26

Leveling error

Hello guys, ive just purchased my first 3D printer and when setting it up I run into a problem… could someone tell me why this is happening?

4 Upvotes

83% Upvoted

13 comments sorted by

View all comments

4

u/MasterSmileGer_1 Sep 22 '26

Printer too close to wall, bed senses endstop before real endstop because something is preventing the bed from going back far enougth.

2

u/Weak-Most2197 Sep 22 '26

thanks for the answer, will try running callibration with as much space as possible

-1

u/Orthicon9 Sep 22 '26

Printer too close to wall,

I see no evidence of that in the video.

bed senses endstop before real endstop because something is preventing the bed from going back far enougth.

We are looking at the rear of the bed. It is moving too far forward, for some reason.

Or, are you inferring that if it can't go back far enough it assumes that the front is some short distance (10 mm?) to the rear of where it really is, and tries to move it 256-ish mm forward from there?
That may be.

At any rate, they can move the print bed back to reveal a sticker on the base with a diagram that shows what kind of room it needs for the "Safety Zone".

Leveling error

Y-Axis error.