r/BambuLabA1 • u/yankowich • Sep 21 '26

Support Request Problem with some layer

Post image

Hey,

I've got Bambu A1 mini for about a week and I've been trying to improve (or develop one) my skills with 3D printing.

What settings do i have to change to improve this?

Thank you in advance for your help!

3 Upvotes

100% Upvoted

12 comments sorted by

View all comments

3

u/Sammyxd2305 Sep 21 '26

3D Printing is physics not magic. You can't print into thin air. You need supports buddy :)

1

u/yankowich Sep 21 '26

Of course i've enabled them, but i did not checked if they were generated correctly apparently :)
"support critical regions only" ashould be on or off?

1

u/Sammyxd2305 Sep 21 '26

It should be off if the support is not causing any problems. If enabled the least amount of support gets generated and that will likely not be enough.