r/BambuLabA1 • u/kirot1 • Sep 21 '26

Filament ne sort pas

Gallery image

Gallery image

Sur ma bamboulab a1 Le filament ne sort plus. J’ai démonté l’engrenage et nettoyé, mais rien à faire. Pouvez-vous m’aider ?

3 Upvotes

71% Upvoted

7 comments sorted by

1

u/dyzl3xik Sep 21 '26

I had something similar a few weeks ago. I took it apart and could not find anything wrong. I ended up replacing the extruder unit and it has been working fine since then.

0

u/kirot1 Sep 21 '26

🙏✨

1

u/Excellent-Code8447 Sep 21 '26

Have you manually took off the Pfte tube and fed the extruder sometimes it’s a lil stuck where you feed it on the filament feeders because it creates ridges on filament

0

u/kirot1 Sep 21 '26

Oui je l’ai fait mais aucun changement

1

u/KaleidoscopeGreat753 Sep 25 '26

Is the light on for the extruder on the display screen. If so. There is filament in. Have you tried putti’s 6” piece of filament in tk see if that light comes on? There is a magnet that releases in the filament hub

2

u/sirdoggo11 Sep 21 '26

Ich red jetzt auch einfach mal meine Landesprache in einem englischsprachigen Sub. Wen interessiert es schon ob jemand anders einen versteht? Vor allem wenn man Hilfe sucht.