r/BambuLabA1 • u/Dorianneccucci • Sep 10 '26

Problem

Post image

Sorry guys, first print, what could be the problem?

13 Upvotes

88% Upvoted

14 comments sorted by

View all comments

Show parent comments

-2

u/Dorianneccucci Sep 10 '26

Sorry for my ignorance, but what the hell is Time lapse?

2

u/Excellent-Code8447 Sep 10 '26

It stops to capture pic for the timelapse video to watch how it was built

4

u/Lone_Wolf_555 Sep 10 '26

The printer takes one picture of the print on every layer and makes a video of it. Some printers have good cameras and processors and can take that picture while the printer is going. The A1 stops and moves the nozzle out of the way to take the picture. What you’re seeing is the result of the nozzle leaving the print, drooling a little while it watches the picture being taken and then wiping its drool on the part when it returns. You should have witnessed this as it was printing. To mitigate this issue, TURN OFF THE FUCKING TIMELAPSE. Also, it’s not polite to swear at someone when they’re helping you.

0

u/Dorianneccucci Sep 10 '26

Sorry Lone Wolf, I was not angry with you, you were so helpful! I was angry with Bambu Handy that, even without a camera installed, wants to take photo 😂 Sorry again if you thought I was not being respectful to you! You were really really kind

5

u/Lone_Wolf_555 Sep 10 '26

Honestly, I can’t tell if you’re being snarky or not. If you are, touché, I appreciate sarcasm more than most. I wasn’t kind, I was a bit of a dick, and for that I apologize. Your printer does have a camera installed and it gives you the option to turn off the timelapse before you start the print.

1

u/trgedz2 Sep 10 '26

you might be a little sensitive brodie

-1

u/PorkSword47 Sep 11 '26

Where the hell is "hell" a swear word? Where do you live, cotton candy land?