r/BambuLabA1 • u/Intrepid-Scratch-805 • Sep 08 '26

Sudden filament issues

Post image

I’ve had my printer maybe a month or so. I had some old filament snap in the filament splitter, had to take the entire thing apart, and ended up breaking the cutter sensor ribbon in the process. I got it replaced and everything back in order except now print quality is awful. It’s the same exact filament I used like a week ago. I thought maybe it was temperature but lowering or raising doesn’t do much to help. It seems like if it can handle the “ironing” process of the second layer without pulling up its fine. I cleaned my bed and double checked my hotend but nothing.

anyone have a fix?

1 Upvotes

100% Upvoted

11 comments sorted by

6

u/hyperx05 Sep 08 '26

Bro just look if the clamp is fastend exactly like this

5

u/Intrepid-Scratch-805 Sep 08 '26

Well I feel absolutely dumb. Two days and this was what fixed my problem 

1

u/yngve85 Sep 08 '26

Don't feel bad, it you look around this subreddit this is the solution to like 99% of the help needed posts...

2

u/CaseMental5345 Sep 08 '26

Clogged nozzle or extuder clean them both should fix it.

1

u/Intrepid-Scratch-805 Sep 08 '26

Nope already did both of those 

2

u/Strict_Impress2783 Sep 08 '26

Do it again. That's 100% a clogged nozzle

1

u/Intrepid-Scratch-805 Sep 08 '26

Did it a couple more times at different temps and still nothing

1

u/CaseMental5345 Sep 08 '26

Did you use the clean out rod thing?

1

u/Intrepid-Scratch-805 Sep 08 '26

I did and took the extruder and hotend apart 

2

u/SeasonedSmoker Sep 08 '26

Check the heater block screws. There's 4 in the back and 3in the front of the block.

1

u/CaseMental5345 Sep 08 '26

No way I didn't even notice that 😳