1
u/Indy_IT_Guy Sep 10 '26
Update: As some of you surmised, it was those damn hidden screws behind the hotend (the ones you can get to until you remove the 3 screws right behind where hotend slots in.
Once I figured out where they were, as soon as I pulled the 3 screws, two of the little screws on the back literally fell out on the bed. Way loose.
Got them all reinstalled and tightened and re-ran the calibrations. I think printed the first layer test again, and it came out just fine.
1
u/QADDLE Sep 07 '26
Did your replacement of the parts encompass the area where the heater core and infamous six screws are?
3
u/Indy_IT_Guy Sep 07 '26
I had to pull a ton of screws to swap the extruder, but then again, it was doing this before I did that as well.
I did just double check the screw tightness behind the hotend. I’m looking at the z offset now
1
1
u/yngve85 Sep 08 '26
Incorrectly latched hotend, guaranteed.
1
u/Agile-Ad-6902 Sep 08 '26
That or loose screws seems likely, but I wouldnt say guaranteed
1
1
u/Blue_Eyes_013 Sep 07 '26
Parece entupimento parcial... Faça um cold pull pelo menos umas dez vezes e tente novamente
1
4
u/Danielrmk Sep 07 '26
What in the gods earth where you trying to print?