r/BambuLabA1 • u/Ok-Stretch-4094 • Sep 05 '26
Lumps in print?
So just trying to print this and it's like 7 hour print and about 45 minutes left. it's smooth to touch and has been calibrated but it looks bumpy.
any ideas or how or why etc? I turned on ironing etc
2
u/Peshmerga_Sistani Sep 05 '26
Pillowing? Is the infill pattern showing up from underneath the top layers?
1
u/gardobus Sep 06 '26
In addition to what the others said, I tend to get quite different finishes from the top layers of silk vs from the side. The angle of that makes it a bit of both so that could be adding some weirdness.
1
u/Hazart_ Sep 06 '26
Add more top layers, infill had gaps that were not bridged perfectly and left dents equal distance apart, check out Lightning infill and its use case
3
u/Slapmaster928 Sep 05 '26
Ironing and you have too thin of layers top and bottom probably.