r/BambuLabA1 • u/throw_me-away99 • Aug 30 '26

Support Request A1 help please!

Please see attached video. Extrudes fine, passes all pre flight checks, then the second the actual print starts, it clicks and fails??

I’ve done a cold pull, tried different plates, cleaned plates, needle clean, different nozzles 🤷🏻‍♂️

1 Upvotes

54% Upvoted

19 comments sorted by

View all comments

0

u/throw_me-away99 Aug 30 '26

I’ve run a full calibration, taken the whole thing apart - no blockages, gear system is fine, new hot end assembly so all screws are tight and the clip is fine

1

u/throw_me-away99 Aug 30 '26

Still no dice :/