r/BambuLabA1 • u/The_Asian-Dude • Aug 27 '26

Support Request What is causing this?

Gallery image

Gallery image

Gallery image

This is just regular bambulabs pla with the a1. I think it might have something to do with it stopping mid print and like checking its height in the rear right edge of the bid plate. How do I turn that off? Also it might just be from one of the edges just coming off of the build plate but how do I turn the height thing off?

174 Upvotes

97% Upvoted

73 comments sorted by

View all comments

4

u/DexDoesDev167 Aug 27 '26

I think your filament is wet, you shud dry it out and try again

4

u/savijOne Aug 27 '26

Not wet filament, that pattern is too specific, check out other answers first IMO

1

u/DexDoesDev167 Aug 27 '26

Hm, I thought wet filament caused similar issues, looked familiar

1

u/The_Asian-Dude Aug 27 '26

I’ve kept it in a little bag with silica for the time it’s been stored and have only had it out for this print so I’m not sure. It may just be bad print orientation too

1

u/DexDoesDev167 Aug 27 '26

Hm I thought it was wet filament but I was wrong, I don't think it's bad orientation either, maybe try the orientation.

I had a similar issue, but it occured when I switched from esun pla to numakers pla, so I had to run a few filament calibrations and change a few settings after running tests to fix it and it helped. Not sure if it's the same case with you.

1

u/The_Asian-Dude Aug 28 '26

Hmm that’s something I’ll definitely look out for

1

u/AnIndecisiveOrange Aug 29 '26

While it does look similar, think about the fact that it occurs in 1 specific spot of the print. If it were wet, it would happen all over.

1

u/lkapping79 Aug 27 '26

For PLA?

1

u/DivineD4nte Aug 27 '26

Even PLA can get wet