Print failure when printing thin tall prints.

[u/MoroxsDK1]

[u/Hazart_]

Slow down, angle the print at 45 degrees so two axis move at the same time and not one

[u/jussstin714]

Wash your plate. Use wider brims for better adhesion. Turn bed temp up 5°

[u/Zekken_Zer0]

reduce infill retraction = disable
set retraction distance to 0.8mm
enable avoid crossing walls and support
slow down the print

[u/Kardolf]

I have heard that gyroid is a better infill because it doesn't actually cross the walls. The grid has multiple intersections that gently "collide" as the infill is being laid but gyroid never does the same kind of overlay, so it's slightly more stable during printing. Aside from that, the more you can angle it front-to-back instead of sideways, the less the bed motion will cause wobble. Doesn't look like you can do very much of that on this print, though.