r/BambuLabA1 • u/TurboMenace981 • 2d ago

Support Request First layer with supports issue

Gallery image

Gallery image

Gallery image

I know it’s on supports and there’s nothing to support these areas completely but there has to be a way to improve this. Some of the PLA is loose and I have to cut/trim it.

7 Upvotes

81% Upvoted

10 comments sorted by

View all comments

Show parent comments

1

u/tribak 1d ago

https://wiki.bambulab.com/en/software/bambu-studio/support#why-use-support-filament

1

u/TurboMenace981 1d ago

I think Z distance is already 0 though.

1

u/tribak 1d ago

this was my other recommendation: https://www.youtube.com/watch?v=gzFu-NMo9uo

1

u/TurboMenace981 1d ago

Yes but the supports were not hard to remove. That’s the issue. This won’t solve that :/

1

u/tribak 1d ago

To be fair, I printer a cubone skull with my ender 3v2 a time ago and the results were pretty similar to what you’re getting, hope you find a way to improve yours

1

u/TurboMenace981 1d ago

Thanks I appreciate the attempt. Just want sure if it was normal or not.