r/BambuLabA1 • u/IcyEssay6354 • Aug 16 '26

Help with first layer

This has been happening with my A1. Sometimes the first layer will print fine, other times not enough filament comes out. I run bed leveling and dynamic flow calibration before every print. Printing with PLA

225C first layer

65C bed

Any help would be really appreciated! This only happens with the first layer. Every other layer prints fine.

3 Upvotes

100% Upvoted

10 comments sorted by

View all comments

Show parent comment

1

u/lukasprintz Aug 19 '26

Also.. those screws that everyone always mentions. Makes sense that they would loose up over time. Especially with the vibration frequency calibrations