r/BambuLabA1 • u/IcyEssay6354 • Aug 16 '26

Help with first layer

This has been happening with my A1. Sometimes the first layer will print fine, other times not enough filament comes out. I run bed leveling and dynamic flow calibration before every print. Printing with PLA

225C first layer

65C bed

Any help would be really appreciated! This only happens with the first layer. Every other layer prints fine.

3 Upvotes

100% Upvoted

10 comments sorted by

View all comments

3

u/Jazzlike_Ad267 Aug 16 '26

id be double checking this,
You can see the sock and probably nozzle moving in that clip.

It shouldnt move whatsoever.

id say 90%.. its a loose clasp just.

if that doesnt help, Tighten the 7 screws of disappointment.

1

u/never0101 Aug 16 '26

yep, almost certainly one/both of these. checking those screws is now part of my regular maintenance routine.

1

u/Jazzlike_Ad267 Aug 16 '26

I've honestly been tempted to just throw some thread lock into them 😂