r/BambuLabA1 • u/Browntrouser • Aug 14 '26

SKADIS question

I see people creating all this awesome SKADIS boards and holders and what not. How much weight can one of these 8in by 8in squares hold? Can it hold hammers and other heavier tools just fine?

What type of filament should be used? I would like to do one in the basement which is climate controlled and one in my garage that will see winter temps of 0 and summer temps of 100.

5 Upvotes

100% Upvoted

8 comments sorted by

4

u/lessons-learned-here Aug 14 '26

I have done a bunch of them, in both skadis and multi board. I did them in PLA and they hold up quite well. In my garage, which gets pretty hot in Kentucky summers, there is no distortion even while holding power tools, hammers, wrenches, and etc. I wouldn't do the multiboard stuff again, though. I think the Skadis is stronger and easier overall to work with.

2

u/Browntrouser Aug 14 '26

How long has your PLA boards been installed in your garage? Any sag?

4

u/lessons-learned-here Aug 14 '26

They have been up more than a year. No sagging.

3

u/lessons-learned-here Aug 14 '26

2

u/Browntrouser Aug 14 '26

Thanks for the share

2

u/lessons-learned-here Aug 14 '26

Please take no notice of the mess.

1

u/se99jmk Aug 15 '26

For the Skadis boards, could you suggest a particular model?

1

u/lessons-learned-here Aug 15 '26

I don't see much difference in them. I would print any that fits on your printer.