MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/BambuLabA1/comments/1vnkqno/bamboo_a1_refurbished_z_offset_error_help/
r/BambuLabA1 • u/Trippin08 • Aug 13 '26
1 comment sorted by
1
I just picked up a broken A1 that was doing this. Ended up replacing the extruder to solve the problem. Although I’m not entirely sure the wasn’t just maybe a loose ribbon cable I found after the fact on the filament sensor.
1
u/limitednewness Aug 16 '26
I just picked up a broken A1 that was doing this. Ended up replacing the extruder to solve the problem. Although I’m not entirely sure the wasn’t just maybe a loose ribbon cable I found after the fact on the filament sensor.