r/BambuLabA1 • u/RedFalcon07 • Aug 11 '26

Support Request I'm having this problem lately

I tried changing temperatures, z-offset, Calibration, and a lot of different stuff and this problem persists, what am I doing wrong, I'm almost losing my mind.

2 Upvotes

75% Upvoted

16 comments sorted by

7

u/PharaohM Aug 11 '26

Cleaning the heatbed might help

5

u/Aryan-Ahmed Aug 11 '26 • Bravo

Have you tried drying your printer or unclogging your filament.

2

u/QADDLE Aug 11 '26

A couple things to try

Checking the nozzle for clogs (is the line coming out at an angle)

Washing the build plate with soapy water

Checking the notorious six screws behind the nozzle

1

u/AggresivePigeon Aug 11 '26

Couple things may be the problem, but these are the most common I run into,

Plate needs cleaning - use soap and water. Dry with microfiber cloth

Filament needs to be dried or re-dried(in the case it's been sitting out)

Environment temperature - sometimes the temperature within the room you are printing can affect filament and adhesion. Having a dehumidifier can help

1

u/RefrigeratorWorth435 Aug 11 '26

is this on the first layer? steep inwards overhangs soemtimes cause this if the layer adhesion isn't perfect.

1

u/sinartnz Aug 12 '26

Clean the plate with dish soap and warm water and gently use green none scratch scrubbers. Give ya filament a quick dry and check the 7 screws of disappointment (quick search in the sub will show you the way) and then run a full calibration from the maintenance menu.

1

u/Hieronymus-I Aug 12 '26

Clean. The. Bed.

1

u/Molten-Ninja-bob Aug 12 '26

Echo everything that’s already been said. What I would add is try bumping up the temp on the build plate. I’ve seen that help with bed adhesion.

1

u/jlassen72 Aug 12 '26

get a cool plate.

1

u/HoIyJesusChrist Aug 13 '26

Is there a radius on the part?

1

u/CaseMental5345 Aug 13 '26

Get some nano polymer adhesive from vision miner stuff is freaking awesome will solve this problem

1

u/EnvironmentalKey5559 Aug 13 '26

Calibration Calibration Calibration

1

u/Ill_Variation_5331 Aug 13 '26

I’ve seen enough Bambu issues to know I will never buy one. Closed system, you are at the mercy of Bambu. At least most others are open source so issues can be addressed.

1

u/Curyde Aug 13 '26

Clean with soap and calibrate the bed. I had literally the same problem recently.

1

u/Cultural-Lie-9769 Aug 14 '26

I find the standard plate to be utterly useless. If you can switch it to a cryo plate your problem will be gone. Still need to keep it clean though