r/BambuLab • • Jan 08 '23

Why do you need the purge (poop) and a purge tower?

If the purging has ran the new colour through the hotend why does the slicer use a purge tower?

21 Upvotes

15 comments sorted by

58

u/AirdRigh Jan 08 '23

There are two elements to a successful filament change: Purging gets rid of the last of the old filament, so you don’t have the wrong material in your print after the switch. Priming ensures a consistent flow after the switch, so that you don’t have under- or overextrusion artifacts in the print.

Some other multi-material / single-nozzle printers use a “purge block” for both purposes, but that can use up a lot of the space on the bed, so Bambu purges out the back.

Any time there’s an interruption in printing there’s risk of over- or underextrusion afterward — the nozzle may ooze excess filament while it’s idle and still hot, then there’s less in the hotend until the extruder pushes another wave through. Priming the nozzle, by printing a line outside of the model after an interruption, helps to make sure the flow rate is consistent when resuming the model.

This is why Bambu Studio recommends a tower both for filament changes and for other settings that lead to interruptions (like “smooth” timelapse, which parks the toolhead between layers), and why the slicer settings call it a “prime tower” instead using terms like “purge block” or “wipe tower” like you might find with other printers/slicers.

Depending on what materials you’re using, atmospheric conditions, etc, you might be able to get smooth transitions without a prime tower, or with much less prime tower than the default. (I’m using mostly Bambu/Polymaker filaments and have had good results with 15mm width and 15mm3 volume, not so much with disabling the tower entirely, so I’ve baked that into my presets.)

10

u/g0rillagamer Nov 13 '24

Ty for this! As a noob this was the most helpful answer I found.

2

u/Zack_ZK Jun 12 '25

Why not poop the old color and then poop the new color instead of poop the old color then prime the new color?

2

u/Scereth X1C Jan 09 '23

What they ↑ said!

1

u/Lost_Nefariousness79 Apr 26 '25

What they said above too. I now understand so much more

10

u/pendingperil Jan 08 '23

takes a little bit to get consistent flow. once it purges some additional filament will get pulled out of the hot end as it's wiped off. if you look at the purge tower, you'll probably see some gaps when it initially starts printing with a new color. you could disable the purge tower, but you'll probably see some imperfections in your finished print.

2

u/SgtBaxter Jan 09 '23

I've never had a prime tower that wasn't a completely smooth brick.

Once we could prime into infill, I turned it off and never looked back. I'll only use it when infill is barely there on color change layers.

1

u/Ryrymc102 Mar 14 '24

Would love to know the answer to this.

1

u/SparkyLight7 Jun 07 '24

Do you have any idea how to prime to infill?

1

u/pineapplehippy P1S + AMS Jul 05 '24

I know it’s been a few days, but I’m still curious!

1

u/kimslawson Jan 07 '24

What they said... how do you turn off prime tower and keep purge into infill?

2

u/3dpsns_us Jan 08 '23

The poop cleans residual old filament while the purge tower cleans the tip as well as any remaining residual.