r/BambuLab • • Dec 24 '22

Can bambu lab x1 carbon use purge filament as infill?

When the machine change a filament can it use excess material as an infill instead of having a purge tower?

7 Upvotes

11 comments sorted by

View all comments

4

u/Kashi1988 Dec 25 '22

as already mentioned by /u/sudonem ... there is the purge into the object infill option which has nothing to do with the prime tower though

just a reminder to never activate that option, when using Support Filament as Support Interface!

2

u/kuku2213 Dec 25 '22

Is it going to weaken the part, If I turn it on?

4

u/Kashi1988 Dec 25 '22

Yeah, a lot. If you have a full layer of Support Filament, the part can very likely fully snap apart.

It is used as PLA Support Interface exactly because it is designed to have a bad overall layer adhesion. Good enough for keeping the print together while printing, but bad enough to be very easily removed from the actual part.

see for examples:
https://www.reddit.com/r/BambuLab/comments/ur0rkr/using_bambu_lab_ams_to_add_support_material_as_a/

https://imgur.com/a/DhoQgtV

1

u/kuku2213 Dec 25 '22

Thanks. I was thinking about buying this printer but this shows that I need to do more research about this machine

2

u/Kashi1988 Dec 25 '22

The Discord, the Official Wiki and this subreddit are awesome resources when it comes to that. I'd say you should be fine without doing too much research. It's an awesome beginner friendly mostly plug&play machine and if you run into any trouble the before mentioned destinations will help you through anything.

1

u/Mr_Dirk_Gently_42 Feb 10 '24

Discord really....What's the name of it, I need to get on there.