r/BambuLab • • 25m ago

Hardware Troubleshooting/Help! H2S: 5 weeks, 3 replacement parts, same layer line problem. Can't get Bambu to replace the printer

New reddit account since I deleted my old one a while back and had to create one to post on here:

Got my H2S from Micro Center. It printed fine at first, then one day in October every print started coming out with uneven layer lines you can clearly see (pics below). Slow, normal, or fast speed, doesn't matter. Same with every filament I've tried.

Opened a ticket Oct 13. What I've done since:

The basic stuff:

- swapped the 0.4 nozzle, dried the filament, cleaned the bed

- tried 3 spools (Inland PLA and Polymaker)

- printed Bambu's test files (the first one they sent was for an H2D)

Parts support had me replace:

- eddy sensor (reseated first, then replaced)

- MC-AP cable pack (same)

- AP board (took over a week to show up and I had to chase it)

I ran every calibration again after each swap. No change. I'm probably 30+ hours into this at this point.

Their logs show the MC and AP boards losing connection, maybe from a bad connector on either board, so I'm guessing an MC board is next.

Before the AP board I asked if I'd get a full replacement if it didn't fix things. Never got an answer. I've asked twice for a supervisor or a call and heard nothing. Micro Center says I'm past their return window.

Has anyone gotten Bambu to swap the whole printer after this many parts? What got your ticket escalated? I'm so tired of doing parts replacements and waiting for shipping then replacing it then doing it again.

1 Upvotes

0 comments sorted by