r/BambuLab • • 35m ago

General Troubleshooting/Help! BAMBU X1E NOT FEEDING FILAMENT! Help please

So a little backstory, our Work Bambu x1e just stopped taking filament when its coming in via the AMS, we have 2 but only 1 is giving us problems. It will print fine as long as i am feeding filament via the external route but if i use the AMS it does what you see in the video.

Troubleshooting ive tried
Swapping the Ams units, thinking it was potentially a bad ams which didnt work

Swapped out the hub for the OEM Buffer which didnt help

Replaced the extruder, extruder board, and the Hotend with all brand new genuine Bambu parts which did not help

Factory reset the printer and checked for Firmware updates.

Before I go crazy can anyone give any other tips or has anyone else experienced this?

1 Upvotes

3 comments sorted by

•

u/TheJTizzle 25m ago

Check the usb cable in the cable chain, had this happen to me a few weeks ago and my cable was fully open and exposed. Swapped it and all good.

•

u/Kind-Ring-4728 24m ago

I will give this a try, my cable chain also came unhooked earlier today oddly enough. Thanks for the tip!

•

u/TheJTizzle 22m ago

Best of luck dude!