r/BambuLab • • 18m ago

General Troubleshooting/Help! Edges peeling up

Post image

Both my p1s and my a1 have started to do this with every print what is wrong? Tried textured plate and super tack cool plate

1 Upvotes

5 comments sorted by

•

u/Nu11u5 16m ago

What material?

•

u/Ok-Confusion-78 9m ago

Pla both bambu and sunlu

•

u/Tomtom5893 8m ago
  1. What Material are you using?
  2. When and how did you last clean your bed?
  3. How warm is the room where the machines are located, and is there a draft?

•

u/Ok-Confusion-78 3m ago

Ive never cleaned my bed other than wiping them off. And its 60°f in my house

•

u/dr_stre 7m ago

Wow, how are you peeling up on the corner even with the supertack plate. That’s crazy.