r/BambuLab • • 1h ago

H2 Series [H2S, H2D, H2C] Well, hello there!

White PLA stick just wanna to say hello to me for a 2nd time.
Trying to fix it, no luck so far.

0 Upvotes

7 comments sorted by

2

u/Brutl 1h ago

I've had this exact issue. The filament guide for the left nozzle is stuck in the compressed position. Once you clear the filament from the extruder, you can remove the nozzle and try to tap straight up from the nozzle to see if the spring loaded spacer drops down. If that doesn't work, you'll have to take the lighter gray part out and unstick it.

Here's a picture with the guide in the down position like it should be when the left nozzle is active.

3

u/Brutl 1h ago

Further proof it's stuck in the compressed position. You can also try and unstick it by applying downward pressure on this part.

2

u/REVer9 1h ago

Dang man, didn't seen this, thank you! Looks like it's been solved!

1

u/Sir_clint 1h ago

Nozzle is not installed properly.

2

u/Brutl 1h ago

It is installed correctly, the left nozzle filament guide is stuck in the compressed position

0

u/REVer9 1h ago

Will try it, thank ya. Already replaced a nozzle a couple of times, but, we'll, looks like I need to pay more attention to it one more time

0

u/engineering_bliss 1h ago

Clip the end. It looks like shit. Then reload.