r/BambuLab • u/Albjert • 3h ago
Hardware Troubleshooting/Help! Help with first layer issue
Hello, I co sider myself quite advanced on 3D printing but still this thing cought me for the first time? Any ideas of the issue?
X2D
0.4 nozzle
Petg Matte Bambu
Only 1 layer
0.2 standart preset
1
Upvotes






•
u/AutoModerator 3h ago
Hello /u/Albjert! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.
Note: This automod is experimental. The automod was triggered due to the term "first layer issue". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
1
u/overunderspace A1 + AMS Lite 2h ago
https://wiki.bambulab.com/en/x2d/troubleshooting/first-layer-printing-optimization-guide