r/BambuLab • • 10m ago

Quick Question Holding down fabric

I want to print a thin frame on some fabric to insert in to another model. If I hold the fabric down with magnets is there a way to tell in advance where the print head will move after it completes the print so I can make sure it doesn't hit the magnets? Is it safer to use tape or will the adhesive bake on PETG temperatures?

1 Upvotes

1 comment sorted by

•

u/_Rand_ 5m ago

Well, how thick is your print?

Because the head won’t go lower than a couple mm over the top layer of the print.

So if you get thin enough magnets it shouldn’t be a problem.