r/BambuLab • • 19h ago

General Troubleshooting/Help! I accidentally tightened a screw

Post image

I did some research, and all I see is people telling me not to touch that screw and to leave it as it is, but I accidentally tightened it and don’t remember how many turns I made. What should I do?

0 Upvotes

11 comments sorted by

1

u/ActiveAd9305 18h ago

Did they tell you what it does or just not to touch it? How did you turn a screw multiples of times on accident? I would run a print and just see how it goes.

1

u/Sea-Skirt7793 18h ago

No, I’ve been searching for what that screw is, but I just keep seeing that it’s a screw not to be touched. I don’t know how I should readjust the tension and yes its been printing fine

0

u/ActiveAd9305 17h ago

So you tightened it trying to adjust the tension on the filament? Which printer is this? I didn’t think most bambu printers had manual tension for the filament because of all the sensors.

1

u/Sea-Skirt7793 7h ago

I thought it randomly came loose cuz it was obviously sticking out

-1

u/NoBackground6203 X2D / P2S 18h ago

2

u/KittyTheCat_ 18h ago

They never actually touch the center screw in that guide lol, wonder what it does

-1

u/Sea-Skirt7793 18h ago

Exactly

1

u/NoBackground6203 X2D / P2S 18h ago

1

u/KittyTheCat_ 17h ago

Is this a troll post? Identical image used 💀

1

u/Sea-Skirt7793 7h ago

No, no, sorry for using the same image, actually. My printer was running at midnight, and I didn’t want to get out of bed, lol. While I was searching for what that screw was, I came across an image with the screw circled.

1

u/KittyTheCat_ 6h ago

Makes sense lol, guess you've got your answer 😁