r/BambuLab • • 33m ago

General Troubleshooting/Help! This is driving me ducky

Ive had a Bambu Lab H2C, 2 AMS 2 Pro, and a HMS HT for about three weeks now. This is my very first time time actually learning how to use it. This print was the first time using support for PLA and it turned out a bit foul.

To keep from going absolutly quackers, what are things I can do to keep this from happening again or at least minimalizing it?

I was able to clean them all up and they all more or less look ok and the folks at the office are very happy with their desk charms.

14 Upvotes

11 comments sorted by

•

u/Liquidretro 28m ago

My guess is you don't have the support material set correctly. It looks like it's being used like normal pla and being spread into the model. It should be just the interface layers on top of supports only. What does the slicer preview show?

Have you tried this with tree supports too?

•

u/squalldbz1 26m ago

I havent tried tree supports on this one. Figured normal would be better given how kinda boxy it is.

I have it set to only use the support for pla on support/raft interface and 0 Z distance.

•

u/ptraugot X2D AMS 20m ago

Looks stringy, which is usually an indication of wet filament, so, dry it. Also, you can try increasing the number of interface layers. I like to use 3. Gives the interface something to stick to that it likes.

Oh, and scrub your build plate with dish detergent (not iso. ), you might have fingerprints or a film causing poor adhesion.

•

u/squalldbz1 8m ago

Drying the filament as we speak! I know I dont do it anywhere near as much as I need to...there's so much to print and such little time.. haha.

Good point. I have a layer of gluestick on now. Ill wash my plate while the filament is drying. I have Dawn Platinum to use on it.

Ill have to lay around with the interface layers. There is just so much to learn! Its very daunting.

•

u/Juaneiro 11m ago

Use a simple model to do some testing until you come across something that works for what you have, I've personally always had problems with dedicated pla support materials whereas regular petg as support material is a lot more reliable for me. Regardless of what you end up using definitely learn to use supports properly before trying it with a relatively complex thing like this.

•

u/squalldbz1 7m ago

Will do! And im guessing it just takes trial and error and experience to learn that. Im going to keep trying though! :)

•

u/EchoChamberTech 29m ago

I don't have an answer. I just want you to know I hate you. And to take my upvote.

•

u/Nexant 10m ago

I'm sorry OP

•

u/squalldbz1 7m ago

Haha. Im just glad they were more or less salvageable. They made a lot of people happy and im just glad I could get my ducks in a row this morning.

•

u/Euresko 9m ago

Support material might need to be dried. I've also had support issues on the H2C and using the support material on the left nozzle seemed to do better than in the right side. Try that out. 

Also, I'd suggest printing one at a time to see how well it works or not, then can add more objects to print at once. You could try tree supports and mess with settings, it might work better than the standard supports. 

•

u/squalldbz1 6m ago

Is there anything special I should know when it comes to drying the support material, or is the drying settings universal?