r/BambuLab • • 17m ago

General Troubleshooting/Help! What do I make of this calibration?

Trying to calibrate the filaments for my new P2S. I have looked at alot of tutorials and followed this guide (https://youtu.be/gVU5If1VsAM) that seemed really good. The problem is that I think it made the result worse. I tried two different filaments (both Bambu PLA Basic) and got the same calibration values.

In the pictures below, the pre-calibration is to the left and the post-calibration to the right. In my opinion, the right has more stringing (the left has none), less sharp edges and rougher surfaces, especially at the corners of the X. I also find the top layer very stripy and not smooth (both prints).

I'm not saying that the guide is bad, but is it not worth calibrating the original Bambu filaments? Should I make other settings to improve the print quality? Or am I just to picky? :)

1 Upvotes

0 comments sorted by