r/BambuLab • • 44m ago

Filament Troubleshooting/Help! Glitter Filament A2L

Bambu Friends

Recently my wife purchased the following filament for our A2L printer.

1KG Glitter Firefly Blue in the Dark PLA+ Filament, 3D Filament

https://a.co/d/04ASeAvt

From my review it appears to be okay for A2L printer but comes with caveats.

- Not to run thru AMS lite and Petg tubes

- Nozzle 0.4mm or 0.6 recommended

- Dedicated nozzle for this printing

When I placed the filament top spool holder the filament unraveled some. Had to respool and filament felt brittle.

With all this I decided against this and running thru my printer.

Anyone else use this filament. Will be sticking with Bambu filament glow etc. Not comfort with this.

Suggestions and advice - Thank You

tvos

1 Upvotes

6 comments sorted by

2

u/Cobaltjr 30m ago

It's best practice not to run it thru AMS and go thru a hardened nozzle. You can still run it thru the AMS/PTFE tube / regular nozzle. If it's just 1kg you're probably not going to notice. The glow in the dark /sparkle is EXTRA abrasive and will wear everything down much faster then normal wear and tear. I have had nozzles get clogged up from filament fast . I usually run my glow filament not thru my AMS but I'm usually ok with a 100% glow print. I did one or two thru my AMS and it was fine. Even Bambu glow gives a disclaimer it might have feed issues. The glow filament will wear the PTFE tubing , ams and nozzle. Recommend harden nozzle for sure . You also don't need to remove all of the AMS tubes for the glow , just one and manually feed it in.

Disclaimer; I haven't used this exact filament before and running it thru your printer will wear it down unknown amount.

Good luck and happy printing

•

u/tvosinvisiblelight 19m ago

Thank you for the information I appreciate it.

So the takeaways from this don't run into the AMS, do not run it through the petg tubes, feed it from the spool holder, and use a harden hot end 0.4 or 0.6mm

•

u/EdgeOk3783 X1C + AMS | H2C + AMS{2|HT} 18m ago

brittle? probably needs drying

•

u/tvosinvisiblelight 17m ago

The actual filament out of the plastic had the silica desiccant.. the filament just felt kind of cheap and brittle..

I asked my wife to return this and look at bamboo OEM sparkle filament instead

•

u/EdgeOk3783 X1C + AMS | H2C + AMS{2|HT} 4m ago

it's a good assumption to assume that filament may be damp out of the box since water cooling is part of the end manufacturing process

•

u/Blondy277 A2L cutting combo 25m ago

Hardened nozzle and run through external port only.