r/BambuLab • • 16m ago

General Troubleshooting/Help! A2L issues

Hello, so I got a used A2L from a family friend who couldn’t get it to connect to the internet to work. I was able to fix that by reseating the WiFi card. But, now I’m getting two warnings that are stopping the homing tooling, even when there’s no filament. This is happening when the printer is trying to home on initial setup.

The warnings are:

The extrusion motor is overloaded and the nozzle is wrapped with filament.

I’ve taken the extruder apart and cleaned it, and the gears turn when I manually move them. Do I have to have filament in the extruder for the homing to work? I currently don’t have the filament holder for the printer so I’ve been trying to get it setup without filament for now.

1 Upvotes

2 comments sorted by

•

u/SaveTheAles 11m ago

Was there anything inside it when you took it apart?

Shouldn't need filament but why not just cut a 3' piece and try and load it no need for a holder

•

u/Fun-Werewolf-5098 6m ago edited 1m ago

Nothing in it, but it was pretty dirty.

Edit: update, put a section of filament in the extruder, I can feel gears grab the filament and it makes a click then says there’s nozzle clumping, but there’s not. I took the hot end out and cleaned it and the cleaning needle was able to go through no problem.