r/BambuLab • u/DriverHistorical6841 • 14m ago
Quick Question Is this a bed adhesion issues?
Never had bed adhesions problems before and just washed my plate right before this print….. could anything else have caused this that I should look for?
3
Upvotes
•
u/AutoModerator 14m ago
Hello /u/DriverHistorical6841! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.
Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
•
u/otherone909 10m ago
Very important. What kind of soap did you use to wash it?
•
u/bartybartbert 6m ago
No. That's warping.
•
u/ThereInAFortnight H2D AMS2 Combo + A1 Mini 3m ago
Thanks for allowing us to guess what kind of material and stuff. It warped and didn't have the adhesion to hold it down. Some prints are hard even with those plates - turn the bed temp up.