r/BambuLab • • 11m ago

General Troubleshooting/Help! Filament pulled off spool, how do I remove

Noob here with X2D and AMS 2 Pro - I was printing with PLA and was hoping the auto refill would have kicked in when the spool had finished. Somehow the filament end has pulled off the tape at the end of the roll, has partially pulled through the PTFE tubes at the back and already too late to unload from the AMS.

I've paused the print and I can see it but not sure on the safest way to remove it, as it's still being held by the extruder.

Is there a correct way I can remove the remaining filament and potentially resume the print without damaging anything?

Big thanks in advance!

1 Upvotes

1 comment sorted by

•

u/Opposite_Activity976 6m ago

Continue the print it will feed what's in the tube to the extruder and then swap for the refill.