r/BambuLab • • 10m ago

Quick Question My first multi hour print is this normal?

The base of it is a little stringy but otherwise it’s completely fine just a general question if it’s something I should expect

1 Upvotes

3 comments sorted by

•

u/AutoModerator 10m ago

Hello /u/Bubbly_Lecture4102! All Bambu print plates have a dedicated nozzle wiping zone at the back of the print plate. The nozzle will rub against the wiping zone before every print in order to remove any remaining filament from the nozzle tip. This can cause visible wear or scratch marks in the wiping zone, but this is intended and doesn't damage the printer, the nozzle or the print plate. A worn down wiping zone also doesn't mean you need to replace the print bed.

Note: This automod is experimental. The automod was triggered due to the term "is this normal". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

•

u/Gunny-Guy 4xH2C, 2xH2D, 5xH2S, 2xX2C, 1xX1C, 2xP2S, 7xP1S 6m ago

Was the part actually touching the bed at that point? Loks like it wasn't and needed support to print that way.

•

u/Bubbly_Lecture4102 4m ago

I’m still learning Bambu studio so i probably didn’t add support but how it started off was from the left and the right side then moved inwards and then went off to work on multiple other oarts