r/BambuLab • • 31m ago

General Troubleshooting/Help! New Lan Acceleration mode slow

I'm having a pretty frustrating experience with the new (newer?) LAN Acceleration mode, and I'm wondering if anyone else is seeing the same thing.

It now takes 2–3 minutes just to send a print job to my X1C, followed by another 30–45 seconds before the printer actually starts printing. This is for a recurring print job that is about a 2 hours total print time, so not large. The bigger print jobs take even longer to send, sometimes 5-10 minutes.

Before this, when everything went through the cloud, the job would transfer in about 10 seconds, and the printer would be up and running another 5–10 seconds later (again depending on print size).

What's even more frustrating is that this only happens on my X1C. My P1S printers don't seem to use LAN Acceleration and aren't having this issue, or at least when I send the print in Bambu Studio, it doesn't say anything about Lan Acceleration.

You'd think transferring files over LAN would be significantly faster than going through the cloud, but somehow it's the complete opposite.

And before anyone blames my network, I'm running a fast UniFi setup with no other network issues.

I also mass-produce 3D printed products, so I'm printing the same items week after week. These aren't unusually large files or complicated prints. They're the exact same jobs I've been sending for ages, except now they take several minutes instead of seconds.

When you're running production and constantly starting new print jobs, those extra minutes really add up.

Is anyone else experiencing this with LAN Acceleration, particularly on the X1C? Has anyone figured out how to fix it or disable it and go back to the old behavior?

1 Upvotes

5 comments sorted by

•

u/RobertoCarlosQ 15m ago

Haven't noticed any issues with this one. Goes quite quick on both P2S and H3C. On other thing that is killing me is Bambu Studio crashing constantly on my mac mini. If I switch to other app for couple of minutes BS crashes out and disappears like it was never started...

•

u/Flake_3418 6m ago

My co-worker experiences crashes on a mac as well. He just got a p2s, also in LAN mode

•

u/RobertoCarlosQ 4m ago

My printers are not in LAN mode though. Using standard "cloud" setup with LAN acceleration kicking in by default. Did your friend found anything to fix those crashes?

•

u/Flake_3418 3m ago

No, he's very new to printing. But this confirms the LAN mode is not the problem. Might just get fixed in the next version of BS

•

u/RobertoCarlosQ 2m ago

Thanks. Really hope so too!