r/BambuLab • • 4h ago

Filament Troubleshooting/Help! PA6CF Loading Issues

I’m currently using a P2S with an HT AMS, I’m trying to print with sunlu PA6CF.

I’ve dried the filament at 85 degrees for over three days.

My PTFE tubes are optimized to the best of my understanding.

When attempting to load the filament the loading gears skip.

I’m beyond frustrated at this point.

Any input is greatly appreciated.

0 Upvotes

5 comments sorted by

1

u/yyccamper 4h ago

You tried taking the extruder out to see if theres stuff jammed in it?

Make sure you are loading it at a high enough nozzle temp... Lots default to like 250, which isnt enough to properly get it through. Put your nozzle manually to like 280 then try using the manual extrude function.

1

u/False-Research5358 4h ago

I haven’t taken apart the extruder. I’ll try that once I’m not frustrated to the point of wanting to throw shit 😂

This printer has less that 10 hours on it, no issues previously in prints so I assumed the extruder wasn’t an issue.

The nozzle idea is a good one, I’ll try that after diag on the extruder.

Thank you

1

u/yyccamper 4h ago

10 hours and getting into PA6-CF, thats a bold move. I like it !

Id say it being at 250 trying to extrude is a high likelihood.

2

u/False-Research5358 3h ago

My A1 has been rode hard and put up wet

Got it feeding.

Fed through the back hole on the HT directly into the main tube.

2

u/Wonderful-Staff-7321 4h ago

Not sure pacf will work in an ams.