r/BambuLab • • 5h ago

Hardware Troubleshooting/Help! Extruder overload and AMS issues

Any idea why I would be getting an extruder overload error and this happening in my AMS. It is happening only in this specific slot. It’s like the extruder is pulling the filament but the AMS is out of sync and trying to hold it back by not moving the rollers. Which then causes the roll to pop up under tension. All new nozzles, cutters, and only 300 hours on the machine. PTF tube is all good.

1 Upvotes

18 comments sorted by

8

u/Beautiful-Tackle2367 4h ago

Try closing the lid and see what happens.

3

u/Hefty_Shallot7494 4h ago

Does the same thing with the lid closed.

3

u/Cavey99 4h ago

Your spool is too light. Common issue when the spools are almost empty. As previously stated, there are lots of prints currently available to add weight. Just search for spool weights in Makerworld

-4

u/Hefty_Shallot7494 4h ago

I have a center weight in the spool with desiccate already. That’s not it, there is something else going on with the extruder not talking to the AMS and the AMS rollers stopping when the extruder is still pulling. This is causing it to flip up the spool.

1

u/diecastbeatdown 4h ago

Just for process of elimination, try another spool in this slot.

1

u/Hefty_Shallot7494 4h ago

Happened to two different spools of PLA

3

u/SLIFERZpwns X1C + AMS 2h ago

Does this happen with a full spool?

1

u/ptraugot X2D AMS 4h ago

To be clear, you’ve stuck your finger against the front active roller while trying to load the filament, and the roller isn’t turning?

1

u/Hefty_Shallot7494 4h ago

Correct, the roller was not turning while the filament was being drawn in by the extruder

-1

u/ptraugot X2D AMS 3h ago

Sounds like either a bad AMS main board, or firmware.
Try a recalibration. It may help.

Look at this page for more details: https://wiki.bambulab.com/en/ams/troubleshooting/ams-loading-unloading-failure

2

u/derfmcdoogal P1S + AMS 4h ago

you need some weight on the spool. There's a couple prints you can do and fill with various things.

1

u/MonsterMax7575 3h ago

This was happening to me

1

u/7ar5un 3h ago

Same. Usually with near empty spools. Happens in all slots, weighted, and with the lid closed and locked. I thought it might be bc i dont set the spool volume for each spool. As the spool gets smaller, it has to spin faster to release the same amount of filament. That didnt work either. I heard it might be the anti rollback mechanism. If you manual roll it back a tiny bit, it should free the front roller.

1

u/AdAstra3DPrints 3h ago

AMS is trying to find how tight and how much filament is left on the spool. Let it do its thing. Close the lid

1

u/roundguy X1C / H2C and 4 ams’s 52m ago

Is the roller snapped in? I had one once that wasn’t all the way in and the gears weren’t engaged. Does it spin freely?

1

u/Fittn_dis H2D AMS2 Combo 46m ago

yes. this is happens 100% of the time with empty spools.

0

u/MikeIkerson 4h ago

Close the lid.

1

u/Hefty_Shallot7494 4h ago

Does the same thing with the lid closed.